One-piece pole dance training pole, polished, 42 or 45 mm in diameter, strutted. For professional use.
Pressure-mounted installation without damaging the floor or ceiling.
-
Instantly change the swivel/static function with a pin, not a screw
No longer do you have to waste time unscrewing screws to turn a static tube into a rotating one. All you have to do is pull out the pin and it takes a second. In addition, the pin is a magnet that will stick to the base, even if you do not put it in the right places.
-
The top bearing twists to the uneven ceiling in both the non-stick and fixed plate.
This pole dance tube does not require you to have a perfectly even ceiling. In case of slight unevenness, the tube will adjust itself to the vertical, because the upper plate has a swinging bearing.
-
Ability to adapt the pipe to a low room
You can shorten the pipe yourself. To do this, simply remove the upper threaded sleeve from the pipe, and then adjust the length of the pipe to the height of the room by cutting off the excess. There is also no lower limit to the height from which we make pipes.
-
The thickness of the pipe wall adapted to the height of the room
The higher the pipe, the thicker the wall, because long pipes like to bend, so it is important that the pipe by its construction is adapted to the height of the room.
-
The lower base, despite the fact that it is not screwed, has the possibility of screwing.
Sometimes conditions require us to screw not only the ceiling mount, but also the floor plate. If during use it turns out that at your place there are no conditions for the tube to stand without screwing (working floor and working ceiling at the same time, often wooden structures), there is an invisible hole in the base for the screw.
Parameters of the one-piece pole dance pole:
- Weight: 10-15 kg, depending on the length of the pole
- Lifting capacity: 150 kg
- Diameter of the rod: 42.4 mm
- Diameter of ceiling plate: 20 cm
- Diameter of floor base: 15 cm
- Installation/disassembly time: 1-2 minutes
- Warranty period: 12 months
Material: polished stainless steel
Cleaning: With a cloth, any alcohol half and half with water. Do not clean with water alone, because after a few months, black streaks will appear on the surface of polished pipes
Spin-Static Mode Change: Using a pin (clearance between the pin and the hole is 0.5 mm)
Return: No return possible – personalized product
One-piece dance pole is subject to height adjustment within +6 cm from the value specified in the order. Permissible measurement error is 10 mm. The base has the ability to be screwed to the floor. Screwing the pole to the ceiling is recommended from a height above 320 cm, while screwing the pole to the ceiling and floor is mandatory from a height of 350 cm.
IMPORTANT: When ordering, specify the exact height from the floor to the ceiling (place of installation). The height should not be measured against the wall, as such a measurement may be incorrect.
Props Order Department: